New supply Pipework

If you need to move or modify parts of your plumbing system it might involve fitting some new pipework. There are plenty of options for doing this. Firstly plan the route the pies are going to take, keeping bends it to a minimum so that the water can flow freely. Leyton Plumbers fit new pipework.


Under a suspended floor:
Run the pipework in shallow notches cut into the top of the joists, or if there is space to insert it, pass the pipes through holes drilled in the joists. Then, clip the pipe to the side of the joists supported on battens attached between them. The pipework should run at least 50 mm below the top of the joists so they can’t be punctured by nails knocked through the floorboards. Make pencil marks to show the pipe runs. When cutting into joists, try to remove as little timber as possible as they are to strengthen buildings. A Leyton Plumber can fit pipework under floors.


Along walls:
The quickest way is to simply clip the pipes to the wall. The pipes will be less noticeable if you keep them neat, straight and parallel, and if you run them around structures like the chimney breast, or along the skirting board. Plastic ducting can hide them, and you can box them in with plywood and timber battens. You can also build a false skirting to contain them. In a new stud partition wall, run the pipework through the studs and noggins before you cover with plasterboard.


Pipe clips:
Running pipes along the wall or concealed behind or beneath it, it is important that they are firmly clipped at regular intervals, or they may creak or vibrate. Pipe clips are various styles and sizes to suit all fits.

Insulating pipes:
To lag any pipes that are at risk from freezing use split foam tubes. You should also lag hot water pipes to prevent heat loss.


“